Vehicle
36 recalls affect this vehicle. Sorted by severity, then date.
Altec is recalling certain 2011-2025 Aerial Device, Digger Derrick and Service Body vehicles because the cable step wire rope assembly may be improperly secured, allowing the entry step to detach.
Altec is recalling 2018-2021 Aerial Devices and Digger Derricks because cracks in the subbase bulkhead plate can cause shear plate failure, increasing the risk of injury.
Altec Industries is recalling 2017-2021 aerial devices because incorrect hydraulic plumbing could allow booms to overextend, increasing the risk of tipping and injury.
Altec is recalling 2017-2018 aerial devices because rotation bearing fasteners may crack and break, potentially causing the pedestal and turntable to separate.
Altec is recalling 2018-2020 digger derricks and aerial devices because a hydraulic check valve snap ring can fail, causing unintended boom movement.
Altec is recalling 2017-2020 aerial devices due to a power take-off that may leak oil onto the exhaust heat shield, increasing fire risk.
Altec is recalling 2018-2020 aerial devices and digger derricks because bolts securing the pedestal to the turntable may fail, increasing the risk of injury or death.
Altec Industries is recalling 2018-2019 aerial devices that were not stability tested according to ANSI A92.2 standards, posing a risk of collapse.
Altec is recalling 2012-2019 aerial devices because a winch valve defect may allow lifting beyond rated capacity, increasing injury risk.
Altec Industries is recalling 2018-2019 aerial devices because high-strength fasteners may fail, potentially causing the pedestal to separate from the turntable.
Altec Industries is recalling 2017-2019 LS60 Aerial Devices because they may not meet stability requirements, creating a risk of overturning and injury.
Altec is recalling 2018-2019 aerial devices because high-strength fasteners securing the pedestal to the turntable may fail, increasing the risk of injury or death.
Altec is recalling 2003-2019 aerial devices due to potential air brake pressure loss. Owners should contact dealers for free inspection and repair.
Altec is recalling 2017-2018 aerial devices because fasteners securing the rotation bearing may break, potentially causing the pedestal to separate from the turntable.
Altec is recalling 2016-2019 LR7 Series Aerial Devices because they can operate without rear outriggers, creating a risk of collapse and injury.
Altec is recalling 2017-2018 aerial devices because turntable fasteners may fail, potentially causing the pedestal and turntable to separate.
Altec is recalling 186 aerial devices from 2017-2018 because under-hood wiring may be damaged by sharp edges, increasing the risk of a fire.
Altec is recalling 2018 Digger Derricks and Aerial Devices because high-strength fasteners may fail, causing the pedestal to separate from the turn table and increasing injury risk.
Altec Industries is recalling 2018 cranes, digger derricks, and aerial devices because overtightened fasteners may break, potentially causing the platform to separate from the vehicle.
Altec Industries is recalling 2008-2018 Aerial Devices with aluminum work platforms because mounting holes may fail, causing unexpected movement and injury risk.
Altec is recalling certain 2004-2023 AT Series aerial devices because cables in the engine compartment may contact the hood, damaging the cables and causing a short circuit that increases fire risk. Free repair available through Altec.
Altec is recalling 2016-2022 digger derricks and aerial devices because a missing weld on the rear pole rack could cause the pole to drop, increasing injury risk.
Altec Industries is recalling 2015-2022 DT65 and DT85 Aerial Devices because a weld crack could cause the auger bracket to detach, increasing injury risk.
Altec is recalling 2017-2021 aerial devices because a wire may be damaged by a sharp edge, potentially causing an engine stall and increasing crash risk.
Altec is recalling 2017-2021 SK185-MP and SKC landscaping spray vans because they lack carbon monoxide detectors, increasing the risk of injury from undetected gas.
Altec is recalling 2016-2021 aerial devices because improperly secured fuel line clamps may cause leaks and increase fire risk.
Altec is recalling 2017-2021 LS60 aerial devices because bearing bolt washers may interfere with welds, causing bolts to break and increasing injury risk.
Altec is recalling 2016-2021 LS87 aerial devices because bearing bolt washers may interfere with welds, causing bolts to break and increasing injury risk.
Altec is recalling 2005-2021 aerial devices because boom spools can shift, increasing injury risk. Owners should contact Altec for free repairs.
Altec is recalling 213 digger derricks from 2016-2020 that lack the required combined use capacity chart, posing an injury risk to operators.
Altec is recalling 2015-2018 aerial devices because a software issue can cause the boom to move unexpectedly during an engine cycle, increasing injury risk.
Altec is recalling 2014-2020 Aerial Devices with Class 3 towing hitches that may have incorrect load ratings or damage from overloading, increasing crash risk.
Altec is recalling 2017-2018 Aerial Devices, Service Bodies, and Digger Derricks because Whelen accessory brake lights may illuminate without the brake pedal being pressed.
Altec is recalling 2017-2018 aerial devices and digger derricks because a step on the fiberglass platform can break off, increasing injury risk.
Altec is recalling 2017-2018 LS63 Aerial Devices because an incorrectly placed battery fuse may increase the risk of an electrical short and fire.
Altec is recalling 2012-2018 aerial devices missing a placard stating maximum towing limits, which could lead to an overloaded receiver tube and increased crash risk.