Vehicle
12 recalls affect this vehicle. Sorted by severity, then date.
Altec is recalling certain 2011-2025 Aerial Device, Digger Derrick and Service Body vehicles because the cable step wire rope assembly may be improperly secured, allowing the entry step to detach.
Altec is recalling certain 2020-2024 LR7 and LR8 aerial devices because a hydraulic cylinder feeder tube may become damaged and leak oil, which can result in uncontrolled boom movement.
Altec is recalling 2019-2022 AT335 aerial devices because an inverter-powered outlet may lack ground-fault protection, increasing the risk of injury or fire.
Altec is recalling 2019-2022 AT41ME aerial devices because the material handling interlocking valve may lose power, allowing the jib winch to operate while outriggers are up, which increases the risk of the unit tipping.
Altec Industries is recalling certain 2022-2024 Aerial Devices because fuel lines may not be properly secured, potentially causing fuel leaks and fire risk when an ignition source is present.
Altec is recalling certain 2004-2023 AT Series aerial devices because cables in the engine compartment may contact the hood, damaging the cables and causing a short circuit that increases fire risk. Free repair available through Altec.
Altec is recalling certain 2021-2023 aerial devices with Bobcat welders that may be misaligned, allowing fasteners to loosen and the welder to detach, becoming a road hazard and increasing crash risk.
Altec is recalling certain 2022-2023 Digger Derricks and Aerial Devices due to missing circuit breakers on AC power inverters, which could cause electrical fires. Altec will install the circuit breaker free of charge.
Altec is recalling 2020-2023 aerial device trucks due to collision mitigation system software that may not be calibrated correctly, preventing the active braking system from activating. This increases the risk of a crash.
Altec is recalling 2021-2023 aerial devices, digger derricks, and related equipment because water can leak into strobe lights, causing electrical short-circuits that increase fire risk. No injuries have been reported.
Altec is recalling 2016-2022 digger derricks and aerial devices because a missing weld on the rear pole rack could cause the pole to drop, increasing injury risk.
Altec Industries is recalling 2015-2022 DT65 and DT85 Aerial Devices because a weld crack could cause the auger bracket to detach, increasing injury risk.