Certain 2019–2021 BMW Models Recalled for Brake System Defect
BMW is recalling certain 2019–2021 models due to improper welding of the integrated brake system rotor and shaft, which could separate during hard braking and cause loss of braking assistance. Owners should contact BMW customer service at 1-800-525-7417 for a free replacement.
What this means for you
Our assessment, not the agency’s: severity 4/5 (Severe).
The hazard poses a serious risk of illness, injury, or structural failure. Stop using the product immediately and contact the manufacturer for a refund or repair.
Our severity reasoning: This recall involves a structural defect in the critical braking system that could result in loss of braking assistance during hard braking events, increasing crash risk. Structural vehicle defects are classified as Severe per the NHTSA rubric.
Plain-English summary
BMW of North America, LLC is recalling certain 2019–2021 BMW vehicles equipped with integrated brake systems. The rotor and shaft within the integrated brake system may not have been welded properly, which could cause these components to separate during hard braking events. This separation could result in loss of the Antilock Brake System (ABS) and braking assistance, increasing the risk of a crash.
The affected vehicles include the 3 Series, 4 Series, 7 Series, 8 Series, X5, X6, and X7 models from model years 2019–2021. A total of 893 vehicles are potentially affected.
To remedy this issue, BMW will replace the integrated brake system at no cost. Owners were notified by mail on May 25, 2021. Owners should contact BMW customer service at 1-800-525-7417 to schedule a replacement appointment. Additional information is available through the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236.
The recalled product
- Product
- BMW M850I, X5, 750LI, M760LI
- Brand
- BMW
- Manufacturer
- BMW of North America, LLC
- Category
- Vehicle — Braking System
- Affected units
- 893
Is your product affected?
Check your packaging against the codes below. If any of them match, the product is part of this recall.
Model numbers (12)
- M850I
- X5
- 750LI
- M760LI
- X7
- X6
- 745LE
- 740LI
- 840I
- M8
- M3
- M4
Distribution
Distributed nationwide across the United States.
Related recalls
Same brand · BMW
- SevereBMW Recalls 2018-2020 Models for Loose Battery Cable Fire Risk
NHTSA · 2026-10-21
- SevereBMW Recalls 2021-2024 R 18 Motorcycles for Fire Risk
NHTSA · 2026-10-07
- SevereBMW X3 Vehicles Recalled Due to Potential Loss of Steering Control
NHTSA · 2026-08-12
- SevereBMW Vehicles Recalled Due to Potential Loss of Power and Rollaway Risk
NHTSA · 2026-08-12
- SevereBMW S 1000 RR Motorcycles Recalled Due to Potential Engine Stall Risk
NHTSA · 2026-07-23
Same manufacturer · BMW of North America, LLC
See all →- SevereBMW Recalls 29,119 Vehicles Due to Starter Relay Fire Risk
NHTSA · 2026-07-08
- SevereBMW and Toyota vehicles recalled due to engine starter fire risk
NHTSA · 2026-07-08
Same hazard · brake failure
See all →- SevereFord Recalls ABS Modules With Incorrect Software Programming
NHTSA · 2026-10-20
- Severe
- Severe
- SevereNova Bus Recalls 2024-2025 LFS Transit Buses for Parking Brake Defect
NHTSA · 2026-09-22
- Severe
Similar recalls
- HighBMW and MINI vehicles brake system failure integrated module welds break
NHTSA · 2024-09-18
- HighIntegrated brake system malfunction in 2023-2025 BMW and MINI vehicles
NHTSA · 2024-02-12
- SevereBMW Recalls 428 Vehicles for Integrated Brake System Malfunction
NHTSA · 2026-07-01
- HighBMW seats may not restrain occupants properly in crash
NHTSA · 2023-03-29
- SevereBMW Recalls 2020-2021 Models for Driveshaft Breakage Risk
NHTSA · 2021-02-03
- SevereCertain 2020-2021 BMW X5, X6, X7 models: suspension weld separation
NHTSA · 2020-11-04