Vehicle
13 recalls affect this vehicle. Sorted by severity, then date.
PACCAR is recalling certain 2009-2024 Kenworth trucks because the air tanks have an insufficient volume of air for the brake system, which can reduce braking performance.
PACCAR is recalling specific Kenworth and Peterbilt trucks because a vent tube may detach, allowing engine oil to contact hot surfaces and cause a fire.
PACCAR is recalling 2011-2016 Kenworth trucks because water may leak into the wiper motor, causing wiper failure and potential electrical fires.
PACCAR is recalling 2007-2014 Kenworth T800 and W900 trucks because brake chambers may take too long to apply or release, increasing crash risk.
PACCAR is recalling certain Kenworth and Peterbilt trucks because the fast idle control may activate while in gear, causing unexpected acceleration and crash risk.
PACCAR is recalling certain Kenworth trucks because a casting defect in the brake slack adjuster housing could cause it to fracture, increasing stopping distances or causing the vehicle to pull during braking.
PACCAR is recalling specific Kenworth and Peterbilt trucks because a loose engine oil filter cap may leak oil onto hot exhaust parts, creating a fire hazard.
PACCAR is recalling certain Kenworth T660, T700, T800, and W900 trucks because the air disc brake caliper could be installed on the wrong side, potentially causing interference with suspension components and reduced braking performance.
PACCAR is recalling certain 2011 Kenworth and Peterbilt trucks because a defective seal may allow engine oil to leak onto hot exhaust components, creating a fire risk.
Kenworth is recalling certain 2011 T270, T370, and T800 trucks because a misassembled air governor may delay emergency brake activation.
PACCAR is recalling specific Peterbilt and Kenworth trucks because the ABS warning light may fail to illuminate if power is lost, increasing crash risk.
PACCAR is recalling certain Kenworth T800 and T660 trucks because door labels may overstate load capacity, increasing the risk of tire failure and crashes.
Kenworth is recalling 2011 T660, T800, W900, C500, T440, and T470 trucks because a harness connection may become unseated, causing exterior lighting power loss and reduced visibility.