The Recall Desk
SevereNHTSA·25V737000·Announced 2025-10-29

Mazda CX-50 front suspension bolts may allow wheel detachment

Mazda is recalling certain 2025 CX-50 and CX-50 Hybrid vehicles because the front suspension fastener bolts may not be tightened properly, which can result in suspension component or wheel detachment.

What this means for you

Illness, injury, or structural failure has been reported. Stop using the product immediately and contact the manufacturer for a refund or repair.

Our severity reasoning: Rubric level 4 covers structural vehicle defects: under-tightened suspension fasteners can allow a wheel to separate from the vehicle, which the source states causes a loss of vehicle control.

Plain-English summary

Mazda North American Operations is recalling certain 2025 CX-50 and CX-50 Hybrid vehicles. About 1,007 units are potentially affected.

The front suspension fastener bolts may not be tightened properly, which can result in suspension component and/or wheel detachment.

NHTSA states that wheel or suspension component detachment can cause a loss of vehicle control and a loss of drive power, increasing the risk of a crash.

Dealers will inspect the front suspension fastener bolts and, if necessary, replace and tighten them, free of charge. Owner notification letters were mailed on December 10, 2025. Owners may contact Mazda customer service at 1-800-222-5500, or the NHTSA Vehicle Safety Hotline at 1-888-327-4236.

The recalled product

Product
MAZDA CX-50, CX-50 HYBRID
Brand
MAZDA
Manufacturer
Mazda North American Operations
Category
Vehicle — Suspension
Hazard
Affected units
1,007

Is your product affected?

Check your packaging against the codes below. If any of them match, the product is part of this recall.

Model numbers (2)

  • CX-50
  • CX-50 HYBRID

Distribution

Distributed nationwide across the United States.

Related recalls

Same brand · MAZDA

Same manufacturer · Mazda North American Operations

See all →

Same hazard · structural failure

See all →