Vehicle
16 recalls affect this vehicle. Sorted by severity, then date.
Altec is recalling certain 2011-2025 Aerial Device, Digger Derrick and Service Body vehicles because the cable step wire rope assembly may be improperly secured, allowing the entry step to detach.
Terex is recalling 2011-2016 aerial devices because inadequate welds at the boom tip may cause the platform to tilt unexpectedly, increasing the risk of user injury.
Terex is recalling 386 model year 2013-2015 Digger Derrick and Aerial Devices trucks because vertical cylinders may drift when loaded, risking platform falls.
Terex is recalling 2014-2015 Digger Derricks and Aerial Devices because fasteners may fail, causing the boom to fall and risking injury.
Terex is recalling 2006-2014 TLM series aerial devices installed on Ford F550 vehicles due to a potential frame crack that could cause loss of control.
Terex is recalling 2012-2013 Digger Derricks and Aerial Devices because damaged outrigger seals may cause the unit to overturn, increasing injury risk.
Terex is recalling 2012 T292, TL, and NT Aerial Devices because a faulty inverter may fail to provide ground fault protection, posing an electrocution risk.
Terex is recalling 2012 utility trucks with SCM Aerial Devices because the leveling arm may break, potentially causing occupants to fall.
Terex is recalling 2008-2010 Digger Derrick and Aerial Device vehicles because improperly heat-treated lanyard anchors may fracture, posing a risk of injury or death.
Terex is recalling 444 Digger Derricks and Aerial Devices from 2012-2017 because a hood switch may prevent remote engine shutdown, increasing injury risk.
Terex is recalling 2007-2016 aerial devices and digger derricks because the onboard electrical breaker may fail to trip during a short circuit, increasing the risk of user injury.
Terex is recalling 2007-2013 aerial devices because missing reinforcements may cause the pedestal to crack, increasing injury risk.
Terex is recalling 2008-2015 aerial devices because cylinder components may contact structural parts, potentially causing platform tilting and occupant falls.
Terex is recalling 2011-2015 SCM48, SCM50, and SCM55 aerial devices because a defective leveling cylinder linkage can cause the platform to tilt, posing an injury risk.
Terex is recalling 1998-2005 OM Aerial Devices because fatigue cracks in the leveling arm may cause failure, risking injury to operators.
Terex is recalling 240 model year 2000-2009 aerial device utility trucks because a hydraulic seal failure may cause the boom to move unexpectedly.