The Recall Desk
SevereNHTSA·25V575000·Announced 2025-09-04

2025 Jeep Wagoneer S Recalled for Incorrect Cross Beam

Chrysler is recalling certain 2025 Jeep Wagoneer S vehicles with an incorrect cross car beam in the instrument panel. The defect may not adequately protect occupants in a crash.

What this means for you

Illness, injury, or structural failure has been reported. Stop using the product immediately and contact the manufacturer for a refund or repair.

Our severity reasoning: This is a structural vehicle defect affecting crash safety and occupant protection. The source explicitly identifies a violation of Federal Motor Vehicle Safety Standard 208 with potential for injury if an impact occurs, meeting the Severe criteria for structural vehicle defects.

Plain-English summary

Chrysler (FCA US, LLC) is recalling certain 2025 Jeep Wagoneer S vehicles. The vehicles are equipped with an incorrect cross car beam in the instrument panel, which causes them to fail to comply with Federal Motor Vehicle Safety Standard number 208, "Occupant Crash Protection."

An incorrect cross beam may not adequately protect occupants in a crash, increasing the risk of injury. Approximately 8 vehicles are affected by this recall.

Owners should contact Chrysler customer service at 800-853-1403. Dealers will replace the cross beam free of charge. Owner notification letters were mailed on October 16, 2025. Vehicle Identification Numbers (VINs) involved in this recall are searchable on NHTSA.gov. Chrysler's reference number for this recall is 71C.

The recalled product

Product
2025 JEEP WAGONEER S
Brand
JEEP
Manufacturer
Chrysler (FCA US, LLC)
Category
Vehicle — Structural / Safety
Hazard
  • crash-protection-defect
  • structural-defect
Affected units
8

Is your product affected?

Check your packaging against the codes below. If any of them match, the product is part of this recall.

Model numbers (1)

  • WAGONEER S

Distribution

Distributed nationwide across the United States.

Related recalls

Same brand · JEEP

Same category