The Recall Desk
SevereNHTSA·17E041000·Announced 2017-07-28

Dana Spicer Steer Axles Recalled for Potential Steering Loss

Dana is recalling Spicer D-Series and E-Series steer axles because the castellated nut may not be properly torqued, allowing the tie rod to loosen and potentially disconnect.

What this means for you

Illness, injury, or structural failure has been reported. Stop using the product immediately and contact the manufacturer for a refund or repair.

Our severity reasoning: The recall involves a structural vehicle defect (steering linkage) that can cause complete loss of steering, which aligns with the rubric criterion for a score of 4.

Plain-English summary

Dana, Inc. is recalling certain Spicer D-Series and E-Series steer axles. The defect involves the castellated nut on the steer axles, which may not be properly torqued. This condition allows the tie rod to loosen.

If the tie rod loosens, it may disconnect from the steering knuckle. This failure causes a complete loss of steering and increases the risk of a crash. The recall affects approximately 25,300 units.

Dana will notify the manufacturers of the commercial vehicles that purchased these axles. Those manufacturers will conduct recalls, and their dealers will inspect the torque of the castellated nut and tie rod, tightening it as necessary, free of charge. The recall began on August 22, 2017. Owners may contact Dana customer service at 1-877-777-5360 or the NHTSA Vehicle Safety Hotline at 1-888-327-4236.

The recalled product

Product
STEERING:LINKAGES:TIE ROD ASSEMBLY recall
Manufacturer
Dana Driveshaft Manufacturing, LLC
Category
Vehicle — Steering Component
Hazard
Affected units
25,300

Distribution

Distributed nationwide across the United States.

Related recalls

Same manufacturer · Dana Driveshaft Manufacturing, LLC

See all →

Same hazard · loss of steering

See all →