The Recall Desk
SevereCPSC·26723·Announced 2026-08-27

Steelite Pressure Washers Recalled for Shock and Electrocution Hazards

Steelite electric pressure washers are recalled because they lack a ground-fault circuit-interrupter and adequate power cord, posing a risk of serious injury or death.

What this means for you

Illness, injury, or structural failure has been reported. Stop using the product immediately and contact the manufacturer for a refund or repair.

Our severity reasoning: The recall involves a risk of serious injury or death from electrocution, which aligns with the rubric criteria for 'Severe' (significant injury reports or structural defects posing high risk).

Plain-English summary

The U.S. Consumer Product Safety Commission (CPSC) is recalling Steelite-branded electric pressure washers due to a risk of serious injury or death from shock and electrocution. The recalled units are red and black, measure approximately 30 inches high, 10 inches wide, and 12 inches deep, and feature a foam cannon, four quick connect nozzles, and a 20-foot hose. The model number “AZ6041VC” is printed on a label on the back of the pressure washer. About 128 units were sold on Amazon by Longer 3D.

The hazard exists because the pressure washers lack an integral ground-fault circuit-interrupter (GFCI) and an adequate-length power cord. These missing safety features create a risk of electric shock and electrocution. The CPSC has not reported any injuries or illnesses associated with the recalled products.

Consumers should stop using the recalled pressure washers immediately. They should contact Longer 3D by email at [email protected] to request a full refund. As part of the remedy, consumers will be asked to destroy the power washer by cutting the unplugged power cord in half, send a photo of the destroyed product to the provided email address, and then dispose of the item.

The recalled product

Product
Steelite Electric Pressure Washers
Affected units
128

Distribution

Distributed nationwide across the United States.