Recalls
Searchable archive of product recalls from the FDA, USDA FSIS, CPSC, NHTSA, and EPA — translated into plain English, severity-scored from objective criteria, and always linked back to the original government notice.
Every recall on this list has been scored 1–5 against an objective rubric from the agency’s own classification, presence of reported injuries or deaths, distribution scope, and hazard type. The colored severity badge on each card is the score — 5 (Critical) means deaths or serious injuries are reported, 4 (Severe) means significant injury or hospitalization risk, and 3 (High) means a known hazard with no confirmed harm yet. Filter to 3+ (High and above) if you want to skip routine Class-III notices.
The agency chips above control which streams are visible. FDA spans food, drugs, and medical devices. USDA FSIS is meat, poultry, and processed egg products. CPSC is household consumer products. NHTSA is vehicles, tires, and child seats. Nationwide on a card means the recall affects every US state — most do — while a state list means distribution was limited.
Click any recall to see the full summary, affected lot codes and model numbers, the agency’s own classification, and a direct link back to the original government notice for verification.
Minimum severity
Olympus is recalling 28 colonoscopes (Model PCF-HQ190L) due to missing adhesive that protects the device from vibration, temperature changes, and physical shock. The defect could cause device malfunction during procedures.
Integra LifeSciences is recalling the Cranial Access Kit due to a defect in sterile packaging that could compromise product sterility. The device is used for neurosurgical access to the brain.
Olympus is recalling two colonoscopes (Model CF-Q180AL, serial numbers 2602060 and 2603763) due to missing protective adhesive that normally guards against vibration, temperature changes, and shock loads.
Olympus is recalling certain repaired Model CF-HQ190I colonoscopes assembled without protective adhesive, which may cause equipment failure under vibration, temperature changes, or shock.
LINK BiMobile hip implant liners are being recalled because packaging incorrectly identifies the insert type as F instead of G. This labeling error could delay surgery or result in the wrong component being used.
Olympus Corporation recalled 31 colonoscopes lacking a protective adhesive that shields against vibration, temperature fluctuations, and shock. The missing adhesive may affect device structural integrity under physical stress.
Olympus Corporation is recalling 18 colonoscopes with missing adhesive that protects against physical stress. The missing protective adhesive could allow device failure under vibration, temperature fluctuation, or shock.
Olympus Corporation of the Americas is recalling Colonoscope Model PCF-Q180AL units that were assembled without protective adhesive. This missing adhesive protects the device from vibration, temperature fluctuations, and physical shock during use.
The Rebstock Holding rod for fixation, a surgical instrument, may move or twist uncontrollably during use, potentially compromising patient safety if the movement transfers to attached equipment.
Integra LifeSciences is recalling 1,324 cranial access kits due to sterile packaging defects that may compromise product sterility.
Integra LifeSciences is recalling 27 units of its Cranial Access Kit due to defective sterile packaging that may compromise product sterility. The kits were distributed worldwide.
Olympus is recalling 36 colonoscopes with specific serial numbers that lack a protective adhesive, risking device failure if exposed to vibration, temperature changes, or shock loads.
Olympus Corporation is recalling 97 Colonoscope Model CF-HQ190L units distributed nationwide. The devices were assembled without protective adhesive, risking malfunction under vibration, temperature changes, or shock.
Olympus is recalling 47 colonoscope units (Model PCF-H190DL) because they were assembled without protective adhesive. The missing adhesive may cause equipment failure under vibration, temperature changes, or shock.
Acumed LLC is recalling 2,952,121 units of Acu-Loc bone plates, screws, and accessories distributed worldwide because they were placed on the market without FDA pre-market clearance. The safety and effectiveness of these devices have not been verified by the FDA.
Alphatec Spine recalls IdentiTi ALIF graft bolts after reports of breakage during implantation. Approximately 12,777 devices are affected worldwide.
Integra LifeSciences is recalling 23 units of the Cranial Access Kit due to defects in sterile packaging that may compromise product sterility. Units were distributed worldwide.
Zyno Medical recalls Z800 infusion pumps (Model Z-800WF) with software version 5.2.05 due to a potential alarm volume malfunction. The alarm may revert to low volume, delaying therapy and risking organ failure in extreme cases.
Medline Industries recalls multiple medical device kits and trays manufactured with components that may lack sterility. The affected solutions could be non-sterile, posing a potential safety risk.
Integra LifeSciences is recalling 8,906 units of the Cranial Access Kit because the sterile packaging failed integrity testing, potentially compromising sterility. Units were distributed worldwide.
Medline Industries recalls 844 units of nursing education kits and trays due to potential lack of sterility in Nurse Assist irrigation solution components. Products distributed nationwide and internationally.
EMD Millipore has recalled Schiff Reagent Hotchkiss-McManus (lots 3094 and 3096) because units appear pink instead of colorless. Laboratories should discontinue use of affected units distributed to US states and Canada.
Abbott Molecular recalled M1000 Wash Station units shipped to U.S. customers without FDA approval or registration. The devices were intended for export only and not approved for U.S. distribution.
GRAPHENANO Dental G-CAM denture manufacturing material is being recalled due to machining errors that render the product unusable. The recall affects 354 units distributed in Utah.
Abbott Molecular shipped two in-vitro diagnostic FISH probe kits to U.S. customers that were intended for export only and not approved or registered per U.S. specifications. The recall affects 16 kits distributed across eight states.