Ottobock PushValve Upper Part Recalled for Diameter Specification Defect
Ottobock is recalling PushValve upper parts because some installed valve inserts have a diameter smaller than the specification.
What this means for you
Minor labeling or packaging issue, or a voluntary precautionary recall. Risk of harm is low but real — follow the manufacturer's instructions.
Our severity reasoning: The recall is classified as FDA Class II, and the defect is a dimensional specification issue without reported injuries or illnesses, fitting the criteria for a moderate severity recall.
Plain-English summary
Ottobock Orthopedic Industrie is recalling the 21Y14=S PushValve upper part. The PushValve is a threadless one-way valve intended exclusively for the prosthetic fitting of lower limb amputees to evacuate air from the prosthetic socket.
The recall was initiated because some of the installed valve-inserts have a diameter smaller than the specification. The affected products were delivered between May 1, 2017, and January 19, 2018, and were distributed nationwide in the United States.
Consumers who have this product should contact Ottobock Orthopedic Industrie for further instructions on how to proceed with the recall.
The recalled product
- Product
- 21Y14=S PushValve upper part Product Usage: The PushValves/ MagValves is intended exclusively for the prosthetic fitting of lower limb amputees. The valve is a threadless one-way valve. It is used to evacuate air from the prosthetic socket.
- Manufacturer
- Ottobock Orthopedic Industrie
- Hazard
- Affected units
- 1
Is your product affected?
Check your packaging against the codes below. If any of them match, the product is part of this recall.
Lot numbers (3)
- The products with an article number listed below and delivered between May 1
- 2017 and January 19
- 2018
Distribution
Distributed nationwide across the United States.
Part of a larger recall action
This product is one of 3 recalled by Ottobock Orthopedic Industrie under a single FDA (Devices) recall action. The agency files each product separately, so the size of the action is not visible from this page alone.
See all 3 products in this recall →Related recalls
Same manufacturer · Ottobock Orthopedic Industrie
See all →- ModerateOttobock PushValve Recall for Diameter Specification Defect
FDA (Devices) · 2019-02-20
- ModerateOttobock MagValve Recall for Prosthetic Socket Air Evacuation Defect
FDA (Devices) · 2019-02-20
Same hazard · dimensional defect
See all →- HighMedline ENFit G-tube connectors may leak from dimensional specification failure
FDA (Devices) · 2026-04-08
- HighMedline ENFit G-tube connector kits may leak from dimensional defect
FDA (Devices) · 2026-04-08
- HighAesculap MINOP trocar shafts may be longer than specified
FDA (Devices) · 2026-03-11
- ModerateMedline soft suction canister liner dimensional variation causes difficult fitting
FDA (Devices) · 2024-08-28
- ModerateMedical Device Liner Recalled for Dimensional Variation Affecting Fit
FDA (Devices) · 2024-08-28